Setting
up the serial connection on Windows 98/98SE:
Directions for using a serial cable for
synchronization.
Note:
Download “mdmcisc2.inf” which is the serial driver for the Zaurus and copy it
to your hard drive.
e.g. Create a new folder “Serial-Driver” on your C drive, and
copy “mdmcisc2.inf” into C://Serial-Driver.
1. Open the Control Panel (Start->Select
Settings->Control Panel)
2. Double-click the “Modems” icon, and an “Install
New Modem” Wizard will appear.
Choose “Other” and click [Next] to continue.

Note
that “Modem Properties” may appear instead of the “Install new modem” wizard,
if the PC already has a modem installed. Then click [Add...] to continue.

3. Check the "Don't detect my modem; I will
select it from a list" option, then click [Next]

4. Select “Standard Modem types” in the
manufactures group and click [Have Disk...].

5.
Click [Browse...] and specify the folder that you saved the file “mdmcisc2.inf”
file to.

e.g. Browse the created
folder C://Serial-Driver and click [OK].

Then click [OK].

6. Select “RAS Serial Cable between 2 PCs”, and
then click [Next].

7. Select the “Communications Port (COM1)” that
your Zaurus will be connected to, then click [Next].

8. After successfully installing the new modem,
click [Finish].

9. The Modems Properties dialog box will automatically
appear. If it does not appear, open “Modem” from the Control Panel.
10. Select the installed “RAS Serial Cable
between 2 PCs” from the list, and then click [Properties].

11. Confirm the COM port that your
Zaurus will be connected to and also select the proper connection speed (in
this case 115200).
12. Click [OK] and [Close].

13.
Open the “Dial-Up Networking” icon in My Computer.

14.
The following dialog box will appear, then click
[Next].

Note:
If the dialog box does not appear, double-click the “Make New Connection” icon.

15.
Enter the name “PDA PPP” and also select “RAS Serial Cable between 2 PCs” from
Select a device list. Click [Next].

16. Enter any number for the phone number (It is
not used) and click [Next].

17. Click [Finish].

18.
Select the “PDA PPP” icon in the Dial-Up Networking folder, then right-click on
it and select “Properties”.

19. In the “General”
tab, un-check “Use area code and Dialing Properties”.

20.
In the “Server Types” tab, un-check “NetBEUI” and “IPX/SPX
Compatible” options.
Make sure that only the “TCP/IP”
option is checked

21.
Un-check “Use default gateway on remote network” and then click [OK] and [OK]
